Two Fusible Links: Backs up the overheat switch. If this switch operates, turn the unit OFF, remove the obstruction (clean filters) and let the unit cool off before re-operating. This is normally caused by an obstruction in front of the louvres, or a blocked fan filter. SAFETY DEVICES Overheat Switch: This device automatically cuts the gas off if the heater exceeds a predetermined temperature. Keep flammable materials, trees shrubs etc. However if odours persist switch off the appliance and contact Rinnai. Filter ON When the heater is operated for the first time or after long periods of non use a slight odour may be emitted, this is normal. SAFETY During peak operating periods the filters should be cleaned weekly, however if the “FILTER” warning indicator flashes in the control panel display, turn off the appliance immediately and clean filters before further use. 250 mm This appliance must not be built-in The clearances must be maintained. Heater must not be located below a power socket-outlet. DO NOT use power boards or double adaptors to operate this appliance. A dedicated 240V 10 Amp power point be used with this appliance. Water spillage can cause extensive damage to the appliance and may result in electric shock. SAFETY DO NOT place containers of liquid on top of the heater. DO NOT place articles in front of the louvres. Most aerosols contain butane gas which can be a fire hazard if used near this heater when it is in use. DO NOT spray aerosols in the vicinity of this appliance while it is in operation. DO NOT use or store flammable materials near this appliance. DO NOT place articles on or against this appliance. Combustible materials must not be placed where the heater could ignite them. SAFETY Keep away from flammable materials. DO NOT cover or place articles on this heater. DO NOT allow children or elderly persons to sleep in the warm air discharge from the heater. Young children should be supervised to ensure they DO NOT play with the appliance. The appliance is not intended for use by young children or infirm persons without supervision. SAFETY DO NOT allow children to post articles in the louvres. The appliance must be installed in accordance with the local gas and electrical authority regulations.Such work must be performed by an authorised person. Improper installation, adjustments, service or maintainence can cause serious injury, death or property damage.Failure to comply with these instructions could result in a fire or explosion, which could cause serious injury, death or property damage.INSTALLATION RECORD INSTALLERS / GAS FITTERS DETAILS Installers Name: _ Company Name: _ Company Address: _ _ _ Company Contact Details Telephone: _ The AGA Certification Number is shown on the appliance dataplate. CERTIFICATION The Rinnai Energysaver® Range have been certified by the Australian Gas Association. Service and removal must be carried out by an authorised person. The installation must also comply with the instructions supplied by Rinnai. The installation must conform to local regulations. INSTALLATION REQUIREMENTS This heater must be installed by an authorised person. TABLE OF CONTENTS INSTALLATION REQUIREMENTS. Energysaver® Space Heaters Operation and Installation Manual To Suit Models: Please note: RHFE-556FTR / RHFE-556FDT RHFE-557FTR Flue System Installation Instructions enclosed with Flue Terminal packaged RHFE-1004FTR / RHFE-1004FDT separately.
0 Comments
Leave a Reply. |